Care & Maintenance - Pro-Point 9083577 Mode D'emploi

V1.0
BLOCKAGES
If during operation the cutting tool becomes lodged in a blockage,
accomplish the following:
1. Release the foot switch to prevent the cable from winding, twisting
or building up outside the drain.
2. Place the power feed lever in the reverse position to pull the cable
back and free the cutting tool from the blockage.
3. If the cable and cutting tool cannot be retrieved, release the foot
switch.
4. Allow the cable to stop spinning then grab the cable with both
hands and pull the cable free.
5. Once the cable and cutting tool are free, attach the boring bulb
cutter.
6. Press the foot switch and feed the cable and cutting tool slowly
towards the blockage.
7. Use the cutting tool to gently encounter the blockage and then
retrieve.
8. Examine the retrieved piece of blockage.
8.1 If blockage appears soft, attempt to use the smallest cutting
tool available to first pierce the blockage and allow water to
flow.
9. Use the appropriate cutting tool to clear the remaining blockage.
9.1 Do not force the cutting tool through the blockage as it may
become lodged again. Allow it to chew away gradually at the
blockage.
CARE & MAINTENANCE
1. Maintain the tool with care. A tool in good condition is efficient,
easier to control and will have fewer problems.
2. Inspect the tool fittings, alignment, hoses and power supply cord
periodically. Have damaged or worn components repaired or replaced
by an authorized technician. Only use identical replacement parts
when servicing.
3. Only use accessories intended for use with this tool.
Visit www.princessauto.com for more information
Power-Feed Electric Drain Cleaner 9083577
13