VOLTCRAFT Quadro B6 Notice D'emploi page 74

The following functions are available:
Depending on the set battery type (LiPo, LiIo, LiFe, NiMH, NiCd, Pb), different setting functions are available.
For example, the setting function for the charge end voltage per cell is only available for lithium rechargeable
batteries.
Therefore, always set the rechargeable battery type first and only then the other data, so that the charger can
offer the matching setting functions.
Battery type
BATT TYPE
LiPo
For this, select the rechargeable battery type „LiPo", „LiIo", „LiFe", „NiMH", „NiCd" or „Pb".
As described above, this selection must be made first, since the right setting functions are only displayed
then.
Battery voltage
BATT VOLTS
7.4V(2S)
Depending on the set rechargeable battery type, the rechargeable battery voltage can be set here.
However, it is not possible to set any voltage, but the steps depend on the rated voltage of an individual cell
of the respective rechargeable battery type; see chapter 7.
For example, the rated voltage of a cell in LiPo rechargeable batteries is 3.7 V; the rechargeable battery
voltage can thus only be set in steps of 3.7 V (3.7 V, 7.4 V, 11.1 V, etc.).
Charging current
CHARGE CURRENT
Set the desired charging current here (0.1....6.0 A). It must be selected according to the rechargeable battery used.
Observe that the charging output of the charger is max. 80 W per channel. For rechargeable batteries with
many cells, the maximum charging current is not available therefore.
Discharging current
DSCH CURRENT
Set the desired discharging current here (0.1....2.0 A). It must be selected according to the rechargeable battery
used.
Observe that the discharging output of the charger is max. 10 W per channel. For rechargeable batteries with
many cells, the maximum discharging current is not available therefore.
74
2.2A
1.2A