Installation Requirements; Tools And Parts; Location Requirements - IKEA IMBS104GSS00 Instructions D'installation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Tools and Parts

Tools Needed
Gather the required tools and parts before starting installation.
Read and follow the instructions provided with any tools listed
here.
Measuring tape
Pencil
T10 TORX
screwdriver
®†
No. 3 square and/or No. 2 Phillips screwdriver
Drill
5/64" (2 mm) and 7/64" (3 mm) drill bits
1/4" (6 mm) shim*
* Shim may be needed for 30" (76.2 cm) installation in double-
walled cabinetry (having outer walls that protrude past the
front surface of the cutout opening). See Step 8 in the "Install
the Microwave Oven (30" [76.2 cm] Installation Only)" section.
Parts Supplied
All of the following parts are provided, but not all parts will be
used. The cutout opening size will determine which parts you will
use. See chart below parts list to see which parts are used for
each installation..
A
B
G
A. Side brackets (2)
B. Extension plates (2)
C. 3/8" (0.95 cm) T10 screws (4)
D. 1/2" (1.27 cm) T10 screws (4)
E. 1" (2.54 cm) T10 screws (4)
F. 1
/
" (3.81 cm) square/Phillips screws (2)
1
2
G. Mounting brackets (2)
H. Side trim panels (2)
I. Spacer strips (4)
INSTALLATION
24" (61.0 cm) installation
30" (76.2 cm) installation
TORX is a registered trademark of Acument Intellectual Properties, LLC
®

INSTALLATION REQUIREMENTS

C
D
E
F
H
I
PARTS USED
D, E, G, I
A, B, C, E, F, H, I

Location Requirements

The microwave oven may be located in a cabinet, and/or above
a built-in oven, or below the counter, and/or below a non-vented
cooktop. Check the opening where the microwave oven will be
installed. The location must provide:
Wood cabinetry.
Cutout opening that is plumb and square. See "Minimum
Cutout Dimensions" in the "Minimum Dimensions" section.
Cutout floor that is solid, level, and flush with bottom of
cabinet cutout.
Support for weight of at least 150 lbs (68 kg), which includes
microwave oven and items placed inside.
Grounded electrical outlet. See the "Electrical Requirements"
section.
Minimum installation clearances for installation location.
See the "Minimum Dimensions" section.
Complete enclosure around the recessed portion of the
microwave oven.
3

Publicité

Table des Matières
loading

Table des Matières