Moving And Storage Instructions; Troubleshooting - Schumacher Electric PROSERIES DSR 119 Manuel D'utilisation

8. MOVING AND STORAGE INSTRUCTIONS

8.1 Store inside, in a cool, dry place.
8.2 Do not store the clips on the handle,
clipped together, on or around metal, or
clipped to cables. The clips on the jump
starter are live when the switch is in the
ON position and will produce arcing or
sparking if they come in contact with each
other. To prevent accidental arcing, always
place the switch in the OFF position and
keep the clips on the storage holders when
not using it to jump start a vehicle.
8.3 If the jump starter is moved around the
shop or transported to another location,
take care to avoid/prevent damage to the
cords, clips and jump starter. Failure to
do so could result in personal injury or
property damage.
IMPORTANT: Do not use and/or store the
jump starter in or on any area or surface

9. TROUBLESHOOTING

PROBLEM
The jump starter won't
jump start my car.
The jump starter won't
power my 12V device.
The battery in the jump
starter won't hold a charge.
POSSIBLE CAUSE
Clips are not making a good
connection to the battery.
Connections are reversed.
The jump starter battery is not
charged.
The vehicle's battery is defective.
The 12V device is not turned on.
The jump starter battery is not
charged.
The 12V device draws more
than 15A or has a short circuit
and tripped the internal circuit
breaker.
The battery is bad (will not
accept a charge).
• 9 •
where damage could occur if the internal
battery should unexpectedly leak acid.
8.4 IMPORTANT:
• CHARGE IMMEDIATELY AFTER
PURCHASE
• KEEP FULLY CHARGED
Charge the jump starter's internal battery
immediately after purchase, after every
use and every 30 days.
All batteries are affected by temperature. The
ideal storage temperature is at 70°F. The
internal battery will gradually self-discharge
(lose power) over time, especially in warm
environments. Leaving the battery in a
discharged state may result in permanent
battery damage. To ensure satisfactory
performance and avoid permanent damage,
charge the internal battery every month.
Check for poor connection to
battery and frame. Make sure
connection points are clean.
Rock clips back and forth for a
better connection.
Disconnect the jump starter and
reverse the clips.
Check the battery charge status
by pressing the button on the
front of the jump starter. See
LED Indicators section.
Have the battery checked.
Turn on the 12V device.
Check the battery charge status
by pressing the button on the
front of the jump starter. See LED
Indicators section.
Disconnect the 12V device and
the breaker will automatically
reset. Try the 12V device again.
If it happens again, replace the
12V device.
Have the battery checked.
SOLUTION