Homelite F2015 Manuel D'utilisation page 25

GB
F D E
IF THESE SOLUTIONS DO NOT SOLVE THE PROBLEM, CONTACT YOUR AUTHORISED SERVICE DEALER.
PROBLEM
Engine starts but will not
accelerate.
Engine starts but will not run
at high speed at half choke.
Engine does not reach full speed
and emits excessive smoke.
Engine starts, runs, and
accelerates but will not idle.
Line will not advance.
Grass wraps round shaft
housing and string head.
Spool retainer hard to turn.
Oil drips from muffler.
NOTE: The carburetor adjustment needle(s) are equipped with plastic cap(s) which prevent anticlockwise rotation from
the original factory adjustment. If your unit exhibits specific performance problem(s) where the Troubleshooting Section
recommends an anticlockwise needle adjustment and no adjustments have been made since original purchase,
the unit should be taken to a factory-authorised service dealer for repair. In most cases, the needed adjustment is a
simple task for the factory-trained service representative.
I P NL S DK
POSSIBLE CAUSE
Carburetor requires
adjustment
Carburetor requires
adjustment
1. Check oil fuel mixture.
2. Air filter dirty.
3. Carburetor requires
adjustment.
Carburetor requires
adjustement
1. Line welded to itself.
2. Not enough line on
spool.
3. Line worn too short.
4. Line tangled on spool.
5. Engine speed too slow.
1. Cutting tall grass at
ground level.
2. Operating trimmer at
part throttle.
Screws threads dirty or
damaged.
1. Operating trimmer at
part throttle.
2. Check oil/fuel mixture.
3. Air filter dirty.
4. Carburetor requires
adjustment.
N FIN GR HU CZ RU
English
TROUBLESHOOTING
SOLUTION
Contact a servicing dealer.
Turn mixture needle (17) anticlockwise 1/16 turn (Fig. 18).
1. Use fresh fuel and the correct synthetic 2-stroke oil mix.
2. Clean air filter. Refer to "Replacing and Cleaning
Air Filter" earlier in this manual.
3. Turn mixture needle clockwise 1/16 turn (Fig. 18).
Turn idle speed screw (28) clockwise to increase idle
accelerates but will not idle speed (Fig.18).
1. Lubricate with silicone spray.
2. Install more line. Refer to "Line Replacement"
earlier in this manual.
3. Pull lines while alternately pressing down on
and releasing bump head.
4. Remove line from spool and rewind. Refer to
"Line Replacement" earlier in this manual.
5. Advance line at full throttle.
1. Cut tall grass from the top down.
2. Operate trimmer at full throttle.
Clean threads and lubricate with grease - if no
improvement, replace spool retainer.
1. Operate trimmer at full throttle.
2. Use fresh fuel and the correct synthetic 2-stroke oil mix.
3. Clean per instruction in Maintenance Section.
4. Turn mixture needle clockwise 1/16 or 1/8 turn
(Fig. 18).
18
RO PL SLO HR TR EST LT LV SK BG