Options; Temperature Sensor For Vapor - Heidolph LABOROTA 20 S A Mode D'emploi

E
Descend heating bath lift to LOW.
Turn master switch OFF.
Reset over temperature protector by introducing an insulated screwdriver through the little hole at
the lower right end of the unit. (remove black plastic plug to gain access through panel)

OPTIONS

2
1

53. Temperature sensor for vapor

To display vapor temperature on the control
panel, you'll need the optional temperature
sensor (1) (P/N 14-014-003-06). To install,
remove cap from temperature fitting (2) of glass
kit. Its plug fits the rear #3 terminal connector of
the drive head. Secure in place.
4
3
119