Grounding Instructions - Waring Commercial CB15 Mode D'emploi

For your protection, this appliance is equipped with a 3-conductor cordset.
120 Volt units are supplied with a molded 3-prong grounding-type plug (NEMA 5-15P) and should
be used in combination with a properly connected grounding type outlet as shown in Figure A.
If a grounding type outlet is not available, an adapter, shown in Figure B, may be utilized to enable
a 2-slot wall outlet to be used with a 3-prong plug except in Canada and Europe.
Referring to Figure C, the adapter must be grounded by attaching its grounding lug under the screw
of the outlet cover plate.
Caution: Before using an adapter, it must be determined that the outlet cover plate screw is
properly grounded. If in doubt, consult a licensed electrician. Never use an adapter unless you
are sure it is properly grounded.
Note: Use of an adapter is not permitted in Canada and Europe.
Green/Yellow: Earth Ground • Blue: Neutral • Brown: Live
Note: User installed cord set plugs are not permitted in Europe.
A.
Circuit Grounding
Connected Properly
Grounding Prong
1. Before starting, make sure that the blender cord is
unplugged.
2. Place container assembly on motor base so that it is
firmly seated and not tilting to one side. Plug in blender
cord into outlet.
3. Put ingredients into container and cover it. Always add
liquid ingredients first, unless otherwise specified in
recipe. Do not fill above Max line.
4. Press the Power button
Green LED will illuminate.
For continuous operation, press either the LOW
When finished blending, press STOP
Pulse button
Note: Your CB15/CB15T utilizes a Slow Start
will start in the LOW position for 1 second and then switch to the setting selected. This allows
for a more even blending of ingredients in container.
5a. Always hold container with one hand when starting and while blending. Never operate without
jar lid properly clamped in place.
5b. FOR BLENDERS WITH A TIMER (CB15T)
1. Press the Power button to turn on the blender. Press the UP arrow or DOWN arrow.
The initial time will be 10 seconds.
2. Push the UP arrow to set the time required. The timer will only advance in
10-second intervals. Timer can be set to the maximum of 3 minutes.

GROUNDING INSTRUCTIONS

Adapter
Grounding Plug
Operation
to turn on the blender.
; motor will run on HIGH speed until the button is released.
B.
Cover of Grounded Outlet Box
, MED
. For momentary operation, press the
feature. When pressing MED or HIGH, the unit
™
00:10
Cover
Mounting
Screw
, or HIGH button.
C.