Grounding Instructions - Waring Commercial BB155 Serie Directives D'utilisation

GROUNDING INSTRUCTIONS

• For your protection, Waring
equipped with a 3-conductor cord set.
• 120 volt units are supplied with a molded 3-prong
grounding-type plug and should be used in combination
with a properly connected grounding-type outlet, as
shown in Figure 1.
If a grounding-type outlet is not available, an adapter, shown
in Figure 2, may be obtained to enable a 2-slot wall outlet to
be used with a 3-prong plug.
Referring to Figure 3, the adapter must be grounded by
attaching its grounding lug under the screw of the outlet
cover plate.
CAUTION: Before using an adapter, it must be determined
that the outlet cover plate screw is properly grounded. If in
doubt, consult a licensed electrician.
Never use an adapter unless you are sure it is properly
grounded.
NOTE: Use of an adapter is not permitted in Canada.
Commercial Blenders are
®
4
BLENDER JAR ASSEMBLY INSTRUCTIONS
1. When assembling blade
assembly to jar, beware of the
blades as they are very sharp.
2. Position rubber seal over blade
assembly so that it sits in
between the flats of the blade
assembly and the jar.
3. Insert blade assembly with
rubber seal into the bottom hole
of the jar.
NOTE: To avoid leaking while
blending, be sure the rubber
seal is positioned in between the
blade assembly and the jar. HINT:
Assembling the jar is easier when
the bottom of the jar is facing up.
4. Screw the collar clockwise onto
the jar until it tightly secures the
blade assembly and seal to the jar.
BB155 OPERATION
1. Before starting, make sure
that the blender is unplugged.
2. Always be sure container is properly assembled before
adding ingredients.
3. Put ingredients into container and cover it. Do not fill
above MAX FILL line.
4. With the switch in the OFF position,
place container on blender base. Be
sure container is fully seated and that
drive coupling is properly engaged.
Plug blender cord into outlet.
5. This blender has 2 speed settings:
HI and LO. Press toggle switch to desired position. To
crush ice, always use HI speed setting.
5