Important Safeguards; Grounding Instructions - Waring Commercial Xtreme MX1000XTX Manuel D'utilisation

IMPORTANT SAFEGUARDS

When using electrical appliances, basic safety precautions should
always be followed including the following:
READ ALL INSTRUCTIONS.
1.
2. To protect against risk of electrical shock, do not put appliance in
water or other liquid.
3. Always unplug from outlet prior to handling or cleaning.
4. This appliance is not intended for use by persons (including
children) with reduced physical, sensory or mental capabilities, or
lack of experience and knowledge, unless they have been given
supervision or instruction concerning use of the appliance by a
person responsible for their safety.
Children should be supervised to ensure that they do not play with
the appliance.
5. Unplug from outlet when not in use, before putting on or taking off
parts, and before cleaning.
6. Avoid contact with moving parts.
7. Do not operate any appliance with a damaged cord or plug or
after the appliance malfunctions or is dropped or damaged in any
manner. Return appliance to the nearest authorized service facility
for examination, repair, or electrical or mechanical adjustment.
8. The use of attachments, including canning jars, not recommended
by the appliance manufacturer may cause hazards.
9. Do not use outdoors.
10. Do not let cord hang over edge of table or counter, or touch hot
surfaces.
11. Keep hands and utensils out of container while blending, to prevent
the possibility of severe personal injury and/or damage to the
blender. A rubber scraper may be used, but must be used only
when the blender is not running.
12. CAUTION: Blades are sharp. Handle carefully.
13. Always operate blender with lid in place.
14. When blending hot liquids, remove center piece of two-piece cover.
See hot blending instructions, page 6.
15. The use of ear protection is recommended during extended
operating periods.
16. Do not leave blender unattended while it is running.
17. See cleaning and sanitizing instructions, pages 6-8.
NOT FOR WATERJET CLEANING.
SAVE THESE INSTRUCTIONS
2

GROUNDING INSTRUCTIONS

• For your protection, this appliance is equipped with a 3-conductor cord set.
• 120 Volt units are supplied with a molded 3-prong grounding-type plug
(NEMA 5-15P) and should be used in combination with a properly connected
grounding-type outlet as shown in Figure A.
If a grounding-type outlet is not available, an adapter, as shown in Figure B,
may be used to enable a 2-slot wall outlet to be used with a 3-prong plug.*
As shown in Figure C, the adapter must be grounded by attaching its
grounding lug under the screw of the outlet cover plate.
CAUTION: Before using an adapter, it must be determined that the
outlet cover plate screw is properly grounded. If in doubt, consult a
licensed electrician.
Never use an adapter unless you are sure it is properly grounded.
*NOTE: Use of an adapter is not permitted in Canada and Europe.
Green/Yellow: Earth Ground. Blue: Neutral. Brown: Live.
NOTE: User-installed cord set plugs are not permitted in Europe.
MX1000XTX/MX1000XTP/MX1000XTS
MX1050XTX/MX1050XTP/MX1050XTS
MX1100XTX/MX1100XTP/MX1100XTS
BLENDER SPECIFICATIONS
• Capacity: 64 oz Working Capacity
(48 oz capacity – MX1000XTP, MX1050XTP, MX1100XTP)
• Switch Settings: (2 speeds)
• Speed (RPMs) 30,000
• Rating: 120 Volts - 13.0 Amps
• Base Material: Polycarbonate
• Bearing: High Precision Ball Bearing
• Cord: 6-Foot Three-Conductor Ground Cord with Strain Relief in Base
• Overall Height: 19 Inches
• Weight: 15 lbs
• ETL , NSF listed
C US
• Operating Cycle: 1 min. ON/3 min. OFF
• MX1100XT – 30-Second Countdown Timer
Hi Low Pulse
26,000 30,000
3