Waring Commercial CB15 Mode D'emploi page 4

3. Select and press a speed button; the blender will start and run for that selected time. It will
count down in 1-second intervals and stop at 0. NOTE: If you want to increase or decrease
time while timer is counting down, press UP or DOWN arrows. Timer will increase or decrease
in 10-second intervals. After 5 seconds the timer will turn "Off" and return to manual mode.
4. When using the timer again, the initial time will be the last time set.
NOTE: If unit has been unplugged, the timer will default back to 10 seconds.
6. Allow motor to come to a complete stop before removing container. Never place
the container on the motor base or remove it from the motor base while the motor
is running.
7. Press the POWER button again to turn off the blender.
8. Remove the container from the motor base and empty the contents.
9. Wash and dry container after each use. See separate Cleaning & Sanitizing Instructions
for All Waring Blenders.
10. Not For Waterjet Cleaning.
11. The use of ear protection is recommended during extended operating periods.
TO REALIZE MAXIMUM SERVICE LIFE, OBSERVE THE FOLLOWING PRECAUTIONS:
1. Do not lubricate container bearing, drive shaft, or shaft seals. These parts are lubricated
and sealed at the factory and do not require any further lubrication.
2. Reduce amounts of material processed to less than the full 4-liter capacity when working with
viscous or fibrous materials.
3. When cleaning exterior of container, keep it in normal upright operating position to prevent
liquids from running into the bearing through the bottom end.
Hot Blending Instructions: Important!
To minimize the possibility of scalding when blending hot materials, the following
precautions and procedures must be observed:
• Hot materials are those which are 100˚F (38˚C) or hotter.
• If you are using the standard container lid that originally came with your blender, limit
the amount of material processed to one (1) litre and completely remove the stopper in
the lid before turning on blender. This will allow venting of the rapidly heated and
expanding air present inside container when blender is running.
• Always start blending on lowest speed setting, then progress to desired speed.
• Never stand directly over blender when it is being started or while it is running.
• Constant monitoring of the condition of the container lid gasket and the container lid
clamps is mandatory. Replace these parts if they become worn or loose, or are damaged
in any way.
Note: A special accessory Hot Blending Lid assembly is available which allows safe
processing of larger loads. Order: One-Gallon Hot Blending Lid, Catalog No. CBL-10. If you
are using the special accessory Hot Blending Lid, follow the instructions packed with the lid.
BEFORE PROCEEDING WITH HOT BLENDING, PLEASE REREAD ALL INSTRUCTIONS
IN THIS OPERATING MANUAL.
Motor - Not For Waterjet Cleaning
The Waring Commercial Blender ball bearing motor requires no greasing or oiling. Sealed-in lubrication
provides smooth unit operation.
Container - The stainless steel container can be sterilized without injury to the bearing.
Jar pad to be washed and rinsed in solutions noted in Cleaning and Sanitizing Instructions.
Maintenance