Power Up; Parameter Set-Up; Manual Keypad Set-Up - Icar 5LSA Notice D'utilisation

1.4 POWER UP

At the first power up, the display shows --- which means no parameter has been pro-
grammed yet.
Under these conditions, a manual test of the steps can be conducted to check the con-
nections.
Press the + or – key to connect or disconnect the steps.
WARNING! During this phase, the step control is totally manual and the unit does not
control the reconnection time to allow the capacitors to discharge.

1.5 PARAMETER SET-UP

There are various methods of setting parameters and commissioning the controller to
operate properly, namely:
Section 1.6 MANUAL KEYPAD SET-UP
−
Section 1.9 QUICK SET-UP VIA PC
−
− Section 1.11 AUTOMATIC SET-UP

1.6 MANUAL KEYPAD SET-UP

Place the unit in manual mode and press the
−
MODE key for 5 consecutive seconds.
The wording SEt appears on the display to con-
−
firm access to the basic menu parameters.
Press the MANU/AUTO key to enter the next
−
parameter.
Press the MODE key to return to the previous
−
parameter.
Press the + and - keys to view and change
−
the setting of the selected parameter. If no
key is pressed for a few seconds, the se-
lected parameter is displayed once again.
Exit from set-up is automatic once the last
−
parameter is exceeded.
5 sec
display and modify
previous
parameter
30
parameter
next
parameter