SOLTRON XS Instructions D'utilisation page 55

Presets
When parameter 30 is started, the display will read 0001 for "on".
– Press to go to P32 without changing the setting.
To turn the facial control off:
– Press Reset once and then release it. The display will begin to flash.
– Press until 0000 is displayed.
– Press Reset once then release it.
Facial control is now turned off.
– Press to go to Parameter 32 (P32).
P32 – Facial Lamp Hour Accumulator (not XS-2/35)
This parameter tracks the number of hours on the current lamp bank.
This parameter is resettable and should be reset to zero when the facial
lamps are replaced. When the current lamp hour accumulation reaches
1000, a beep will chime each time the unit is turned on, indicating that a
lamp change is necessary. The chime will not sound if it has been disa-
bled through parameter 02. Parameter 06 and 32 are the only editable
parameters at password level one.
– Press Start/Stop until the display reads 00:00 to exit parameter mode.
To clear the facial lamp hour accumulator:
– Press Reset once and then release it. The display will begin to flash.
– Press until 0000 is displayed.
– Press Reset once then release it.
Facial lamp hour accumulator is now reset to 0 and will begin accu-
mulating at the next session.
Any remaining parameters are for future expansion and are not used
at this time.
To exit the system
– Press Start/Stop until the display reads 00:00 to exit parameter mode.
55