Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

XS-35

Tanning

Start of tanning
– To set the time, press button
. See page 5 for the recom-
mended tanning time.
– To reset the time, press button
, the timer clears to 00:00
– To start the tanning session, press button
. The session is
counted down in minutes and seconds.
– To reset the time after starting, press button
and then
timer clears to 00:00.
22
Preparation time
1)
If a session delay is preprogrammed
, the display will begin to flash the
session time after the button
is pressed.
During the session delay you have time to prepare for tanning:
– Remove your clothes and all jewelry.
– Remove make-up and other cosmetics.
, the
– Remove glasses. Contact lenses can be worn under the protective
goggles.
– Put on the protective goggles.
– Lie down on the bed surface.
– Close the canopy.
Note:
Depending on presets (see page 48), at one (1) minute before
the start of the tanning session, an audible beep will sound. At
thirty (30) seconds before the start of the tanning session, an-
other audible beep will sound. At ten (10) seconds the audible
beep will sound and continue once each second until the tan-
ning unit lights. Once the tanning unit has started, the session
delay will not repeat on subsequent starts (e.g. after interrupt-
ing the session).
1. See page 49

Publicité

Chapitres

Table des Matières
loading

Ce manuel est également adapté pour:

Xs-35 kissXs-35 super powerVhp 15 120w

Table des Matières