Dustcontrol DC Chip Extractor Mode D'emploi page 39

Troubleshooting
Problem
Motor not running.
Motor stops immediately after starting.
Motor runs, but no suction.
Motor runs, but poor suction.
The motor stops during operation.
Machine blows dust.
Abnormal sound from machine.
DC Chip Extractor
Cause
Power supply not connected.
Incorrect fuse.
Suction hose not connected.
Suction hose perforated.
Blocked filter.
Suction hose too long or narrow.
Hose partially blocked.
Top of machine poorly fitted.
Dust trapped in cyclone.
The motor is overheated.
Filter loose or damaged.
39
Action
Connect power supply.
Replace with correct fuse.
Connect hose.
Replace hose.
Clean or replace.
Replace hose.
Reverse or clean hose.
Adjust fitting.
Remove top and clean cyclone.
Check that the machine is not throttled & wait until the machine
has cooled down (approx. 30min).
Check and replace as necessary.
Book service.