Defrosting; Cleaning The Appliance; Odors; Warning Messages Via The Display - Bosch B36ET Série Guide D'utilisation Et D'entretien

Defrosting

The appliance is defrosted automatically.
Cleaning the
appliance
m
WARNING
To avoid electrical shock which can
cause death or severe personal
injury, disconnect power to
appliance before cleaning.
After cleaning, reconnect power.
CAUTION
To avoid personal injuries or property
damage, observe the following:
– Do not clean the appliance with
a steam cleaner.
– Do not let the water used for
cleaning drip onto the light or
control panel.
– Do not use abrasive or acidic
cleaning agents or solvents which
may damage the surfaces of the
appliance.
– Never clean shelves and containers
in the dishwasher. The parts may
warp.

Switch off the appliance with the
on/off button!
Pull out the mains plug or switch off
the fuse.

Clean the door seal with water only
and dry thoroughly.

Clean the appliance with lukewarm
water and a little dishwashing liquid.
Do not let the water used for
cleaning drip onto the control panel
or light.

Check the ventilation openings on
the base panel. Remove dirt with
a vacuum cleaner.
After cleaning:

Reinsert the mains plug or switch on
the fuse. Switch on the appliance
with the on/off button.
Have your supplier inform you
about special cleaning and care
information for appliance surfaces.

Wipe appliance surfaces with
a damp cloth. Then immediately
wipe dry.
m

Odors

If the appliance is emitting unpleasant
odors:

Switch off the appliance with the
on/off button!
Pull out the mains plug or switch off
the fuse.

Take all food out of the appliance.

Clean the interior.
See section on "Cleaning
the appliance".

Clean all packages.

Pack strong-smelling food in airtight
containers to prevent the build up of
odors.

Switch on the appliance again with
the on/off button.

Stack food in the appliance.

After 24 hours check whether the
odors have been eliminated.

Change the odor filter, see
"Changing the odor filter"
Warning messages
via the display
If several warning messages are
displayed simultaneously, deal with each
message individually.
While a warning message is displayed,
buttons cannot be pressed.

Temperature alarm

(Freezer compartment)
A temperature alarm is indicated by the
required temperature flashing and the
ALARM symbol coming on. A signal
also sounds if the Tone function has
been activated in Setup mode.
Cause
– Power failure.
– Large quantities of fresh produce
placed in the appliance.
– Fault with the appliance.
Remedial action

Press the alarm off button.
The signal stops. The highest
temperature in the appliance is
displayed for several seconds.

Determine the cause of the
temperature alarm.
When the required temperature is
reached again, the ALARM symbol
goes out and the signal stops.
17