Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Thermo Call TC3
Heater Harness
For heater applications that did not
originally include a SmarTemp Control fx
controller a jumper harness must be used
in addition to the Thermo Call harness.
This jumper connects between the Thermo
Call TC3 harness and the heater side of
the connection. This jumper is included in
the SmarTemp Control fx kit. Refer to the
Wiring Layout on page 7.
SmarTemp Control fx Heater Harness
For heater applications (Thermo Top C -
TTC) that were designed for SmarTemp
Control fx, this is a plug and play
application. No jumper harness is required.
SIM Card
A SIM Card is required through your local
wireless carrier and is not supplied with the
Thermo Call TC3 kit.
Both 1.8 V and 3 V SIM cards of a network
carrier, which supports the GSM 900/1800
mobile communications standard, can be
used.
Always observe any information of the
respective network carrier when operating
the SIM card. No warranty can be given for
the SIM card used. The SIM functionality
should be checked separately in individual
cases.
Before inserting the SIM card, the PIN code
must be changed to 1234 with a mobile
phone. Information on this procedure is
contained in the respective operating
instructions of the mobile phone.
9
Webasto Thermo & Comfort N.A., Inc.
All data which may be present on the SIM
card will be deleted when inserting into the
GSM module.
The SIM card is inserted under the slide
cover on the top of the GSM module.
Only insert or remove the SIM card in a de-
energized state (module not connected to
power).
The range and fees are dependent on the
respective network carrier. Information on
these topics as well as roaming charges can
be obtained from the respective network
carrier.
Webasto assumes no liability for fees
incurred via the use of a Network Carriers
SIM Card.
Publicité
Chapitres
Table des Matières
