Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Thermo Call TC3
Installation
Installing GSM Module
The GSM module must be installed in the
passenger compartment.
Fasten the GSM module with self-tapping
screws or zip ties (not included). Ensure
sufficient clearance for the connection of
the wiring harness and the antenna.
IMPORTANT
Always make sure there are no obstacles
behind the mounting location prior to
drilling.
NOTE
Please mark the installation location of the
GSM module on page 47 of these
instructions. A vehicle image has been
provided to ensure the customer is aware
of the GSM module location for
installation of their network SIM Card.
Installing GSM Antenna
The antenna must be installed on the front
or rear window. However, never in the
tinted area or under the defrost wires of the
rear window.
Clean the window thoroughly with a
cleaning cloth before attempting to adhere
to surface.
Pull the protective film off the antenna and
affix the antenna. Maintain a minimum
distance of 1 ¼" (30mm) from metal parts.
Route the antenna cable to the GSM module
(never shorten or kink) and connect to the
module.
The antenna must be installed at least 8"
(20 cm) from all persons.
10
Webasto Thermo & Comfort N.A., Inc.
Installing Push Button
The push button control contained in the
delivery scope must also be installed. This
allows for a manual override while inside
the vehicle.
-
To do this, drill an 5/16" (8mm) dia.
hole in a suitable mounting location
easily accessible to the driver
(coordinate the installation location
with the vehicle owner prior to
installation)
-
Mount the push button in the
previously drilled hole.
-
Route the push button wiring harness
to the 12-pin connector on the module
and connect them (blue wire on Pin 9,
green on Pin 10 and red on Pin 11)
Publicité
Chapitres
Table des Matières
