Operation And Programming; Operating With A Phone Call - Webasto Thermo Call TC3 Guide D'installation Et Mode D'emploi

Thermo Call TC3

Operation and Programming

Following entry of up to 15 authorized phone numbers, the TC3 can immediately be operated with the factory settings. For details on
programming the phone numbers, please see the following list of possible text message commands.
You have the following basic options for activating the Webasto parking heater:
•
Switching the parking heater "on" or "off" directly with a phone call.
•
Switching the parking heater "on" or "off" with a text message command.
•
Pre-programming the parking heater within 24 hours with a text message command.
•
Switching the parking heater "on" or "off" with a push button. The heater can be started via the heater control, depending
on its configuration. Before parking the vehicle, the settings required for the model must be carried out (temperature, fan).

Operating with a Phone Call

Select the phone number of the SIM card installed in the TC3. The phone number used to call the TC3 must be saved beforehand in the
unit; see Text message commands. After the connection has been successfully established, the TC3 acknowledges the call with a tone.
•
With the heater switched off, the call is confirmed by the TC3 with 2 tones.
After the connection is disconnected, the parking heater operation starts for the set period of time (factory setting 60 minutes).
The LED of the push button lights up.
•
With the heater switched on, the call is confirmed by the TC3 with 3 tones.
The respective operating mode has ended. The LED of the push button switches over to displaying stand-by mode.
Should the TC3 be called from a phone number not stored, then the connection will be ended by the GSM module without feedback. The
respective heater operating mode remains unchanged.
Webasto Thermo & Comfort N.A., Inc.
16