Webasto Thermo Call TC3 Guide D'installation Et Mode D'emploi page 20

Thermo Call TC3
Text Message Commands (Continued)
Command
1234IBANK:
"Entry command"
1234DTMF:ON
1234ACCLIM:ON
1234ACCLIM:OFF
1234PIN:XXXX:XXXX
VERSION
1234TIMER1:XXX
1234TIMERAUX:XXX =
1234TIMER2:XXX
1234ASPONSE:ON
1234ASPONSE:OFF
Function / Description
In this case any desired command (max. 20 characters) can be defined as to how
the TC3 is to warn in case of an input signal from, for example, an optional alarm
system (e.g. break-in alarm). (Not Supported for North America)
Activates the DTMF tone feedback for a direct call.
Activates the phone number restriction for direct calling.
Deactivates the phone number restriction for direct calling (TC3 can be activated
with any desired phone number).
Changes the access code from 1234 to XXXX.
1234 is the factory setting for the access code and should be personalized by the
user. After this, 1234 must be replaced by the personalized access code.
The firmware version is transmitted.
Entry of the heating or ventilation duration between 001 and 999 minutes. By
entering 000 the respective operating mode is activated in the continuous mode
and must be manually deactivated again by calling, with the "STOP" text message
command or by using the push button.
(Ventilation Not Used In North America)
Entry of the activation time between 001 and 999 minutes. Entering 000 activates
the output in the continuous mode and must be deactivated manually with the
"STOP" text message command.
Each text message command is confirmed with a reply text message.
The reply text message is deactivated.
Webasto Thermo & Comfort N.A., Inc.
20
Factory Setting
Input Active
ON
ON
ON
1234
---
60 Minutes
30 Minutes
ON
ON