Webasto Thermo Call TC3 Guide D'installation Et Mode D'emploi page 19

Thermo Call TC3
Command
TEMP
STATUS
The following 5 commands are only possible with an external sensor installed:
Command
TEMP STATUS
1234LOTEMP: XX
1234HITEMP: XX
1234LOTEMP: OFF
1234HITEMP: OFF
Text Message Commands
Command
1234NBANK:XXXXX:XXXXX
Function / Description
The current temperature in the GSM module or the cab temperature (with an
installed external sensor) is transmitted.
(External Temperature Sensor Not Used In North America)
Shows whether or not the heating or the ventilation mode is active. And if it is, the
remaining running time. The same is shown for Output 2. The current temperature
and on-board voltage are also displayed.
Function / Description
Shows the current temperature and the alarm status (ON/OFF) for the upper and
lower temperature threshold.
Sets and activates the lower temperature threshold. An alarm is set off if the
temperature falls below this value.
Sets and activates the upper temperature threshold. An alarm is set off if this
temperature is exceeded.
Deactivates the temperature alarm for the lower temperature threshold.
Deactivates the temperature alarm for the upper temperature threshold.
Function / Description
Saves up to five phone numbers which will be informed in case of a temperature
alarm, an alarm of an optionally connected alarm system, or in case of a
failure/malfunction of the external temperature sensor.
(Alarm System Connection Not Supported for North America)
Webasto Thermo & Comfort N.A., Inc.
(Not Supported for North America)
19
Factory Setting
---
---
Factory Setting
---
OFF
OFF
---
---
Factory Setting
No Phone Number
Stored