Text Message Commands - Webasto Thermo Call TC3 Guide D'installation Et Mode D'emploi

Thermo Call TC3

Text Message Commands

Command
START
STARTXXXX
STARTAUX = START2
STOP
STOPAUX = STOP2
SUMMER
WINTER
AUTOMODE
Function / Description
Parking heater is switched on.
The start of the respective operating mode can be pre-programmed once for up to
24 hours.
For example: START0700; the respective operating mode is activated at 7:00 a.m. the
following morning. After sending the command, you will receive a reply text message
with the starting time, current time and temperature. The starting time can be
changed with a new text message or with the STOP command or can be deleted by
pressing the push button for at least 3 seconds.
The analogue additional output is activated for the programmed time.
(Not Supported for North America)
The parking heater is switched off or the pre-selection time is deactivated.
The analogue additional output is deactivated.
(Not Supported for North America)
The TC3 changes over from the heating to the ventilation mode.
(Ventilation Not Supported for North America)
The TC3 changes over from the ventilation to the heating mode.
You can define a temperature between 41°F (5 °C) and 95°F (35 °C). From the point
at which the set value is reached, the TC3 automatically changes over to the
ventilation mode.
(Ventilation Not Supported for North America)
Webasto Thermo & Comfort N.A., Inc.
18
Factory Setting
---
---
---
---
---
WINTER
WINTER
OFF