Button Feedback, Faults And Remedies - Webasto Thermo Call TC3 Guide D'installation Et Mode D'emploi

Thermo Call TC3

Button Feedback, Faults and Remedies

The TC3 was developed according to the latest state of technology and the mode of operation is extremely reliable. Malfunctions are often
due to the SIM card, the network operator, poor reception or incorrect operation. Information of troubleshooting is provided in the
following list. Note: The GSM module must be de-energized before removal of the SIM card.
Button Feedback
LED flashes 1x cyclically every 2 seconds
LED flashes 1x cyclically every second
LED flashes 2x cyclically
LED flashes 3x cyclically
LED flashes rapidly (approx. 5x per second)
LED lights up
LED lights up, however parking heater does
not carry out command
Description and Remedy
TC3 is ready for operation.
24 h pre-programming is active.
Network error => contact network operator.
Error in SIM card => check SIM card in a mobile phone and replace if necessary.
Antenna error => check installation location and cable routing and replace antenna if
necessary.
PUK code error => insert SIM card in a mobile phone and enter PUK and PIN code. PIN
code must be 1234 or must be deactivated. Switch on GSM module again following
power interruption.
The TC3 has received more than 20 text messages within 30 minutes and was therefore
automatically shut down. => press push button for at least 3 seconds. This initializes the
system (can take up to 5 minutes).
Parking heater or ventilation has been activated.
(Ventilation Not Used In North America)
Potential problem with parking heater.
Contact your Webasto service partner.
23
Webasto Thermo & Comfort N.A., Inc.