Preventing Damage; Safety Appliances - BDS Maschinen AkkuMAB 3000 Mode D'emploi

Safety

Preventing damage

Safety appliances

Monitoring the rechargeable battery
Restart protection
40
CAUTION
Potential damage to property if the charging device is im-
properly used!
Observe the following instructions to avoid property to damage:
►
Before connecting the charging device, compare the connec-
tion data (voltage and frequency) on the rating plate with those
of your mains power supply. The data must correspond in
order to avoid damage to the charging device.
►
Do not use the connecting cable to carry the charging device.
►
Do not pull the mains cable to remove the plug from the mains
socket.
►
Do not crush the connecting cable.
►
Do not expose the connecting cable to heat or chemical
liquids.
►
Do not pull the connecting lead across sharp edges or hot
surfaces.
The installed electronics protect the rechargeable battery against
total discharge, overheating and short circuiting in order to ensure
the maximum lifecycle of the rechargeable battery and to ensure
that enough residual capacity is available for the magnetic clamps.
NOTE
►
The machine stops automatically when the magnetic clamp is
switched off or the motor overloaded.
In order to prevent the machine from starting unexpectedly af-
ter switching on the magnetic clamp again the machine must be
switched on using the ON/OFF switch.
AkkuMAB 3000