Drilling With The Machine - BDS Maschinen AkkuMAB 3000 Mode D'emploi

Using

Drilling with the machine

Drilling with core drills
50
When drilling with core drills, proceed as follows:
‹
Insert the ejector pin (C) into the core drill.
‹
Insert the core drill with the ejector pin as described in chapter
Inserting the tool.
‹
Place the machine at the working location, align it and switch
on the magnetic clamps.
‹
Switch the machine on.
‹
Direct the drill with the handle (9) to the material.
NOTE
Observe the following instructions when drilling with core drills:
►
Drilling with core drills does not require great force. The drilling
process is not accelerated by higher pressure. The drill wears
faster and the machine can be overloaded.
►
Use high-performance oil in the cooling lubricant system of the
machine.
►
The cooling lubricant system cannot be used when working
overhead. In this case, use the high-performance ZHS 400
grease spray. Spray the drill on the inside and outside before
drilling. Repeat this procedure when drilling deeper holes.
►
Make sure that swarf is removed regularly. With larger drilling
depths, break the chip.
AkkuMAB 3000