Inserting The Tool - BDS Maschinen AkkuMAB 3000 Mode D'emploi

Inserting the tool

Core drill
AkkuMAB 3000
The machine is equipped with a 19 mm Weldon tool mount that can
accommodate core drills up to a length of 55 mm.
WARNING
Risk of injury!
►
Do not use damaged, contaminated or worn tools.
►
Change tools only when the machine is switched off and at a
standstill. Remove the rechargeable battery from the machine.
►
After inserting, check that the tool is engaged securely.
►
Only use tools, adapter and accessories that match the ma-
chine.
Inserting the core drill
‹
Before mounting, clean the Weldon shank and tool mount (2)
of the machine.
‹
Check the the lead connection for lubricant.
‹
Unscrew the two Allen screws in the tool mount using the Allen
key (A) supplied.
‹
Insert the core drill in the tool mount (2).
NOTE
►
Insert the appropriate ejector pin (C) before inserting a core
drill.
‹
Tighten the two Allen screws in the tool mount (2) using the
Allen key (A) supplied.
WARNING
Risk of injury from an incorrectly inserted tool!
►
Check the stability of the core drill.
Removing the tool
‹
Loosen the two Allen screws in the tool mount (2) using the
Allen key (A) supplied and pull the tool downwards out of the
tool mount.
Using
49