Prevention Of Damage; Safety Installations - BDS Maschinen MAB 100 Mode D'emploi

Prevention of damage

Safety installations

Restarting protection
MAB 100
CAUTION
Potential property damage in case of inexpert handling of
the machine!
Observe the following instructions to avoid property damage:
► Before connecting the machine, compare the connection
data (voltage and frequency) on the rating plate with those
of your mains power supply. The data must correspond in
order to avoid damage to the machine.
► Always carry the machine at the handle, not by the connect-
ing lead.
► Always pull the mains lead out of the plug socket at the plug,
not at the mains lead.
► Do not pinch the connecting lead.
► Do not expose the connecting lead to heat or chemical
liquids.
► Do not pull the connecting lead across sharp edges or hot
surfaces.
► Lay the connecting lead in such a way that it cannot be
caught and wound up in the rotating part of the machine.
NOTE
► The machine stops automatically of the magnetic clamp is
switched off or in the event of a power failure.
In order to prevent unexpected starting of the machine when the
magnetic clamp is switched on again or when the power supply
returns after a power failure ("restarting protection"), the machine
must be switched on at the ON/OFF switch again.
Safety
31