BDS Maschinen MAB 100 Mode D'emploi page 38

Preparations
Core drill
38
Inserting the core drill
Before mounting, clean the Weldon shank and tool mount (2)
‹
of the machine.
Check the the lead connection for lubricant.
‹
Unscrew the two Allen screws in the tool mount using the
‹
Allen key (A) supplied.
Insert the core drill in the tool mount (2).
‹
NOTE
► Insert the appropriate ejector pin (B) before inserting a core
drill.
Tighten the two Allen screws in the tool mount (2) using the
‹
Allen key (A) supplied.
WARNING
Risk of injury from an incorrectly inserted tool!
► Check the stability of the core drill.
Removing the tool
Loosen the two Allen screws in the tool mount (2) using the
‹
Allen key (A) supplied and pull the tool downwards out of the
tool mount.
MAB 100