Sony HT-CT100 Mode D'emploi page 22

3
Select the input of the system
connected to the component you want
to watch (BD, DVD, SAT), and switch
the HDMI input of the TV, so that an
image from the connected component
is displayed.
4
Set the Control for HDMI function of the
TV to on.
The Control for HDMI function for the
system and the connected component is
simultaneously set to on.
During the setting, "SCANNING" appears
in the front panel display. After you finish
the setting, "COMPLETE" appears in the
front panel display. Wait until the setting is
complete.
If "SCANNING" or "COMPLETE"
does not appear after performing
the steps above
Set the Control for HDMI function to on for the
system and the connected component
individually.
1
Press AMP MENU.
2
x/X
Press repeatedly until "SET HDMI"
appears, then press
3
x/X
Press repeatedly until "CTRL:
HDMI" appears, then press
4
x/X
Press to select "ON."
5
Press AMP MENU.
The AMP menu turns off. The Control for
HDMI function is set to on.
6
Set the Control for HDMI function of the
connected component to on.
For details on setting the connected
component, refer to its operating
instructions.
7
Select the input of the system
connected to the component you want
to use the Control for HDMI function for
(BD, DVD, SAT), and repeat step 6.
22
US
or c.
or c.
If you add or reconnect the
component
Perform steps of "Preparing for the "BRAVIA"
Sync" and "If "SCANNING" or "COMPLETE"
does not appear after performing the steps
above" again.
Notes
• During the setting of the Control for HDMI function
for the system, the System Audio Control function
does not work.
• If the Control for HDMI function for the connected
component cannot be set simultaneously by setting
"CONTROL FOR HDMI" of the TV, set the Control
for HDMI function using the menu of the connected
component.
• For details on setting the TV and the connected
components, refer to their operating instructions.
Tip
• The default setting of the Control for HDMI function
of the system is "OFF."