Connecting The System - Sony HT-CT100 Mode D'emploi

Notes
• Use screws that are suitable for the wall material and
strength. As a plaster board wall is especially fragile,
attach the screws securely to a wall beam. Install the
satellite speaker on a vertical and flat reinforced area
of the wall.
• Be sure to subcontract the installation to Sony dealers
or licensed contractors and pay special attention to
safety during the installation.
• Sony is not responsible for accidents or damage
caused by improper installation, insufficient wall
strength, improper screw installation or natural
calamity, etc.
8
US

Connecting the system

Connect the active subwoofer and the satellite
speaker as shown in the illustration below.
Rear of the active subwoofer
HDMI
ONLY FOR
SS-MCT100
Rear of the satellite speaker
Connect the speaker cord to the active
subwoofer.
Secure the jack by tightening the two screws.
I N I N
D
D V
O U
T V
T I N
M I
S A R
H D F O
L Y 0
T 1 0
O N
N - M C
D I
D V S S
R
A K E
S P E
SPEAKER
Speaker cord
(approx. 3 m (10 feet))
T