Connectors (Rear Panel Of Drive Unit) - Pioneer PRA-DW11 Mode D'emploi

Connectors (rear panel of drive unit)

6 5
1 Device configuration jumpers
Placing the jumper on a pair of pins turns the pair ON. Confirm that pin set 2 is set for
ON (jumper connected).
2 Host IDE interface
Connect to the PRV-LX1's IDE interface cable (see installation instructions, step 9).
3 DC INPUT connectors
Connect to the PRV-LX1's power cable (see installation instructions, step 9).
Connectors 4, 5, and 6 are not used with the PRV-LX1.
MASTER
SLAVE
CABLE SELECT
C S M 39
ANLOG AUDIO
S L A 40
4 1
DC INPUT
1
IDE INTERFACE
5V G G 12V
2
2 3
7
PRA-DW11
En