Pioneer PRA-DW11 Mode D'emploi page 12

Installation
5 Install the tray panel in accordance
with the instructions noted below, "#
Install tray panel 2 to the drive 2 disc
table."
6 Insert a commercial software disc
marked for use in region 2 in the disk
table, and press the ENTER button
until the disc table closes.
# Install tray panel 2 to the drive 2 disc table
Align the ribs on the accessory tray panel 2 with the slit on the disc table's front
surface, and press in until the hooks engage securely.
NOTE:
When installing tray panel 2, take care not to press the disc table in the closing direction, since
the automatic disc loading mechanism will cause the disc table to be pulled back in. If you
accidentally press the disc table so that it is pulled back in, allow it to close naturally without
touching it, then press the drive 2 EJECT button once again to open the disc table.
NEVER turn off the power during this operation or attempt to pull the disc table out,
since the main unit (PRV-LX1) and this unit (PRA-DW11) may be damaged, and internal
data may be erased.
Tray panel 2
Slit
12
PRA-DW11
En
7 After the monitor screen displays the
Ribs
following message, the PRV-LX will
automatically shut down and enter the
standby mode.
[Monitor screen message]
Mount...
>>
Everything may be OK.
Shutdown Now!!
Disc table
Hooks
Slit