Replacing The Lamp - Sony VPL-FX40 Guide De Référence Rapide

Replacing the Lamp

The lamp used as a light source is a
consumable product. Thus replace this lamp
with a new one in the following cases.
• When the lamp has burnt out or dims
• "Please replace the Lamp and clean the
Filter." appears on the screen
• The LAMP/COVER indicator flashes in red.
(Repetition rate of 3 flashes)
The lamp life varies depending on conditions
of use.
Use an LMP-F270 Projector Lamp as the
replacement lamp.
Use of any other lamps than the LMP-F270
may cause damage to the projector.
Caution
The lamp remains hot after the projector is turned
off with the ?/1 key. If you touch the lamp, you
may burn your finger. When you replace the
lamp, wait for at least an hour for the lamp to
cool.
Notes
• If the lamp breaks, consult with qualified for
personal.
• Pull out the lamp by holding the knob. If you
touch the lamp, you may be burned or
injured.
• When removing the lamp, make sure it
remains horizontal, then pull straight out. Do
not tilt the lamp. If you pull out the lamp
while it is tilted and if the lamp breaks, the
pieces may scatter, causing injury.
1
Turn off the projector, and disconnect the
AC power cord from the AC outlet.
Note
When replacing the lamp after using the
projector, wait for at least an hour for the
lamp to cool.
2
Open the lamp cover by loosening the
three screws with a Phillips screwdriver.
10
GB
Replacing the Lamp
3
Remove the lamp cover by lifting it
forward with the fingers placed on the slit
of the projector.
4
Loosen the two screws on the lamp unit
with the Phillips screwdriver (a), hold the
knob (b), then pull out the lamp unit.
5
Insert the new lamp all the way in until it is
securely in place (a). Tighten the two
screws (b).
Notes
• Be careful not to touch the glass surface of
the lamp.
• The power will not turn on if the lamp is not
secured properly.
6
Restore the lamp cover to the original
position and tighten the three screws
with the Phillips Screwdriver.
Note
Be sure to attach the lamp cover securely as it
was. If not, the projector cannot be turned on.
7
Connect the power cord.
The ON/STANDBY indicator lights in
red.
8
?/1
Press the key to turn the projector on.