Replacing The Lamp - Sony VPL-CX100 Guide De Référence Rapide

Replacing the Lamp

The lamp used as a light source is a
consumable product. Replace this lamp
with a new one in the following cases.
• When the lamp has burnt out or dims
• "Please replace the Lamp and clean the
Filter." appears on the screen.
• The LAMP/COVER indicator flashes in
red. (Repetition rate of 3 flashes)
The lamp life varies depending on
conditions of use.
Use an LMP-C200 Projector Lamp as the
replacement lamp.
Use of lamps other than the LMP-C200
may cause damage to the projector.
Note
If the lamp breaks, consult with qualified Sony
personnel for replacing the lamp and internal
checking.
1
Turn off the projector, and disconnect the
AC power cord from the AC outlet.
Note
When replacing the lamp after using the
projector, wait at least an hour for the lamp
to cool.
2
Open the lamp cover by loosening the
three screws with a Phillips screwdriver.
Note
If you work with the projector hung on the
ceiling, hold the lamp cover so it does not
fall when you release the screws.
10
GB
Replacing the Lamp
3
Place your fingers under the lamp cover
and pull it up to remove the lamp cover.
4
Loosen the three screws on the lamp unit
with the Phillips screwdriver (a), hold the
knob (b), then pull out the lamp unit.
Note
Do not allow any metal objects, flammable
objects, etc. into the lamp replacement slot.
5
Insert the new lamp all the way in until it is
securely in place (a). Tighten the three
screws (b).