Cordless Drill - Parkside Performance Pabsp 20 Li C3 Instructions D'utilisation Et Consignes De Sécurité

{Enable device}
Authorise another user from the same
o
household to use the battery pack via the
Lidl Home app.
{FAQ}
Check current firmware
o
Update of the firmware via
o
firmware upgrade}
{Remove device}
See chapter "Disconnecting the product and
o
deleting data from the app"
˜ Cordless drill
{Device
If you select
o
"PABSP 20 Li C3 (2201)" under {Battery},
the overview page of the cordless drill is
displayed with the following details:
– the ID of the power tool
– the name of the power tool
– the discharge current (in ampere)
– the rotation speed of the motor (rpm)
{Tool work mode}
Select work modes:
o
{Performance}
–
discharge current for heavy duty tasks
{ECO}
–
Rotation direction of the power tool is
o
{CW}
displayed as
(counter-clockwise)
{Light delay off setting}
The light delay off setting of the LED work
o
light after switching off can be set from
[ ]
1 to 99 seconds.
Usage statistics of the cordless drill are
o
displayed as:
– Total run time
46 GB/IE
{Check for
info}
‒ allows higher
{CCW}
(clockwise) or
– Number of over temperature protection
– Number of stalls
– Number of over current protection
{Firmware version}
Checking the firmware version of the power
o
tool:
– If a red dot is displayed next to the version
it indicates that a new firmware version is
available. When you select
version}, you can select
firmware}. The update status bar shows
the transmission of new firmware to the
battery pack.
{Update success}
o
transfer of the new firmware to the battery
pack. The battery pack disconnects from the
Lidl Home app. The firmware update will
start.
m IMPORTANT!
During the firmware update the connection
u
status LED flashes 5× per second. Do
[ ]
not disconnect the smart battery pack
from the cordless drill during the update
as the cordless drill will become unusable
if the update fails. During the update the
cordless drill becomes unresponsive to
input, e.g. triggering the on/off switch. The
update process takes around 5 minutes.
If the firmware update is successful, the
connection status LED flashes 1× per
second for 5 seconds. The cordless drill
becomes responsive to input again. You
can connect the battery pack to the
Lidl Home app following the chapter
"Connecting the product to the Lidl Home
app".
{Firmware
{Update of
means successful