Unit Description; Initial Use; Mains Connection - Beurer TL 90 Mode D'emploi

Repairs
Important
• D o not open the device. Please do not attempt to repair the unit yourself. This could result in serious inju-
ries. Failure to observe this regulation shall void the warranty.
• If you need to have the unit repaired, contact customer service or an authorised dealer.

4. unit description

Overview
1. Fluorescent screen
2. Rear of the device housing
3. Stand
4. On/Off button
5. LED display

5. Initial use

Take the device out of the plastic wrapping. Check the
device for damage or faults. If you notice any damage or
faults on the device, do not use it and contact customer
services or your supplier.
Positioning the device
Place the device on an even surface. The position should
be chosen to ensure a distance of between 20 cm and
40 cm between the user and the device. The lamp is most effective at this distance.

Mains connection

Connect the unit only to the mains voltage listed on the type plate. Push the plug completely into the mains
socket.
Note:
• Ensure that there is a socket near the place where the lamp will stand.
• Lay the mains cable in such a way that no one can trip over it.
6. Operation
1 switching on the lamp
 Press the On/Off button. The tubes turn on. Set the angle of the fluorescent screen in accordance
with your individual requirements.
ATTeNTION!
The brightness of the tubes may be visibly different when switched on. The tubes develop
their full luminosity after a couple of minutes.
5.
11
1.
2.
3.
4.