Before You Start; Checking What's In The Box; Putting The Batteries In The Remote; Using The Remote Control - Pioneer XR-A9700DV Mode D'emploi

1 Before You Start

1
2
3
6
En

Checking what's in the box

Thank you for buying this Pioneer product. Before starting to set up your new stereo
system, please check that you received the following supplied accessories:
• Remote control unit
• FM antenna
• AM loop antenna
• AA/R6P dry cell batteries (x2)
• Power cord
• Speaker cords (x2)
• Video cord
• Warranty card

Putting the batteries in the remote

1 Open the battery compartment cover on the back of the remote control unit.
2 Insert two AA/R6P dry cell batteries into the battery compartment following
the indications (ª, ·) inside the compartment.
3 Close the cover of the battery case.
CAUTION:
• Remove the battery if the remote is not going to be used for a month or more.
• Remove dead batteries promptly—they can leak and damage the unit.

Using the remote control

Keep in mind the following when using the remote control unit:
• Make sure that there are no obstacles in between the remote and the remote
sensor on the unit.
• Use within the operating range and angle, as shown in the diagram left.
• Remote operation may become unreliable if strong sunlight or fluorescent
light is shining on the unit's remote sensor.
• Remote controllers for different devices can interfere with each other. Avoid
using remotes for other equipment located nearby this unit.
• Replace the battery when you notice a fall off in the operating range of the
remote.