Settings Menu - TOOLCRAFT LDM 70 Mode D'emploi

With three reference points (subtraction)
1. Press the button "Indirect Measurement" three times. The indicator
for indirect measurement with three reference points (subtraction)
will be shown in the top of the display.
2. Now measure the three required segments. For the order, refer
to the following drawing or to the relevant flashing segment of the
indicator for indirect measurement.
3. After the third segment has been measured, the height between
reference points 1 + 2 will be calculated automatically and shown
on the display.

17. Settings menu

In the Settings menu, you can access stored readings, change the
display unit, set stake out points and activate the laser pointer.
Accessing stored readings (F1)
1. Press and hold the button "Settings" for approx. two seconds. When
releasing the button, "F1" will be shown on the display.
2. Press the button "+" to browse through the last 20 readings (first
to last).
3. Press the button "-" to browse through the last 20 readings (last to
first).
4. Press the button "Settings" to continue to the next menu item, or
press the button "On/Off" to exit the Settings menu.
40