EIBENSTOCK EDS 125 Notice Originale page 18

Attention!
The PRCD protective switch must not lay in water.
!
PRCD protective switches must not be used to switch
Before starting your work, check the proper function
First, check the correspondence between voltage and frequency against the
data mentioned on the identification plate.
Voltage differences of + 6 % to – 10 % are allowed.
Only use extension cables with a sufficient cross section. A cross section
which is too small could cause a considerable drop in performance and an
overheating of machine and cable.
Switching on and off
Short-Time Operation
Switching-on: press the on/off switch (1)
Switching-off: release the on/off switch (1)
Permanent Operation
Switching-on: press the on/off switch (1) and, keeping it pressed, engage
the lock button (2)
Switching-off: press the on/off switch (1) and let release it again
Instructions for Use
Adjust the cutting depth; see "Adjust cutting depth" section.
Place the sliding block on the workpiece to be cut without allowing the
diamond disc to come into contact with it. Then activate the tool and wait
until the diamond disc has reached full speed.
Align the left edge of the base (13) with your cutting line on the workpiece.
Now slide the tool in a flat and even manner across the surface of the
workpiece until the cut is completed.
To achieve a clean cut, maintain a straight cutting line and a steady speed of
advance. Curved cuts are not possible, as the diamond cutting disc will be
angled into the workpiece.
For absolutely precise cuts, especially at larger cutting lengths, guide rails
(750mm and 1500mm) are available as an accessory.
Do not strain the machine so heavily that it comes to a standstill.
Noticeable decreasing work progress and circular sparking are indications of
a blunt diamond cutting disc. Briefly cutting into abrasive material (e. g. lime-
sand brick or the EIBENSTOCK-diamond-sharpening-stone) can re-sharpen
the disc again.
the tool on and off.
by pressing the TEST button.
18