Rizzoli RTE Série Manuel D'utilisation page 134

5 MAINTENANCE
5.1 CLEANING
The thermal cooker works better if all its parts
are without combustion residuals, a clean thermal
cooker will be less exposed to problems due to
WARNING! All these operations must be done with cold thermal cooker.
5.2 CLEANING THE VISIBLE PARTS
Stainless steel parts have to be cleaned cold with
neutral detersives or with a specific solution for
stainless steel in case of hard to remove dirt. Do
not use at all abrasive sponges that may scratch
the surface. Dry with a soft rag, following the glaz-
ing wise.
In some cases, after the installation or after the
cooking of meals, it might appear a superficial ox-
idised stratus, in particular on the stainless steel
5.3 MAINTENANCE OF THE COMBUSTION CHAMBER SHEETS
Picture 38 – Maintenance of the combustion chamber sheets
wear. Cleaning frequency depends on how much
and how the thermal cooker is used, as well as on
combustible quality.
frame. Also in this case, an accurate cleaning will
make the cooker as new.
On request Rizzoli gives specific products to clean
stainless steel. For enamelled or painted parts, do
not use abrasive and aggressive or acid detersives,
in case of stains pour some oil and wait while it
absorbs the halo, then clean with a soft rag. We
recommend not to use solvents or denatured alco-
hol on painted parts.
1
132
2
1