Beurer IH 30 Mode D'emploi page 11

stop using the medicament cup as soon as signs of wear appear at the tip (cracks, white
marks). Do not use a medicament cup for more than three sessions.
using the Inhalator with accessories (optional)
The Inhalator can be used both with and without a mask. It is advisable for children to use a mask.
During the following procedures, take care not to tilt the Inhalator to prevent mixing of the
water and medicament.
1. Make sure that the Inhalator is switched off.
2. Now push the short, white tube of the inhalation mask (with children the smaller mask) into the
open end of the extension tube.
3. Fit the extension tube into the aperture in the top cover by pushing the tube together slightly at a
smooth end, and push it into the aperture until a slight snap engagement can be heard.
Operation
Make sure that the Inhalator is in the vertical position before you switch it on and thus ensu-
re that it operates correctly with maximum effectiveness.
1. Press the ON/OFF button to switch on the Inhalator. The indicator lamp lights up green.
2. Adjust the filter case at the back of the Inhalator to ensure the required amount of airflow. At
maximum setting, three air holes can be seen.
3. If desired, use the inhalation mask. We also recommend during use of the mask that you
breath in and out through your mouth in order to reach the bronchial system. If your nose
is to be included, breath in through your nose and out through your mouth.
4. Inhale the medicament prescribed by your doctor. The Inhalator is designed so that the inhalati-
on rate increases after a few minutes. It begins at a minimum.
5. When the mist is no longer constant, this indicates that the medicament cup is empty. Inhale
until no more mist is produced or the Inhalator switches off (the Inhalator switches off automati-
cally after 10 min. of use).
6. Switch off the Inhalator by pressing the ON/OFF button. The indicator lamp goes out. Unplug the
power plug of the power line adapter from the socket outlet and unplug the small plug from the
socket underneath the Inhalator.
7. Empty the medicament and water residues (WARNING: HOT!) and clean the Inhalator as descri-
bed under "Cleaning". Allow the Inhalator to cool down for 30 minutes before re-use.
Troubleshooting
If problems still occur despite the following checks, send the Inhalator for repair to the address
appropriate for you.
Problem
The Inhalator does not react when
the ON/OFF button is pressed
Low or no nebulization
The fan is not operating correctly
cause/solution
Check that the power line adapter/battery is
connected to the Inhalator correctly.
Check that the water tank has been properly filled.
Check that the battery is properly charged.
Make sure that the medicament cup is sufficiently full
(min. 2ml - max. 5ml) and is not broken.
Check that the Inhalator under the medicament cup
is clean.
Check that the fan is securely and correctly
connected to the motor shaft.
11