Publicité
Les langues disponibles
Les langues disponibles
INSTALLATION – Exo Terra
Follow this installation procedure to install the Exo Terra
MULTI system on any size of Exo Terra
comes with two nozzles, which should be mounted on either glass side
panel of the terrarium as close as possible to the opening front doors.
1. Unlock the top screen cover and lift it off the terrarium.
2. Slide the inlet holes (located on the back of the screen top on either
side) to the open position, so the tubing will fit through.
3. Feed the tubing through the first inlet hole on each side on the back
of the terrarium. (fig. A)
A
4. Mount the nozzles in position on the glass portion of the terrarium's
side panels with the suction cups. Make sure that the glass area is
clean and free of any dirt or deposits before mounting the nozzles.
For the best results, mount the nozzles as close as possible to the
front opening windows and the top screen. (fig. B)
B
5. Direct the nozzle positions inside the terrarium so that the spray
stream will avoid spraying on the terrarium's front and side panels
when in operation.
6. Use the additional suction cups to neatly guide the tubing along the
side panels to the inlets at the back of the terrarium.
7. Replace the top screen cover and lock it back into position.
8. Close the remaining inlets by sliding the slider against the tubing or
wires to prevent escape from feeding insects and
smaller animals. (fig. C)
Natural Terrariums
®
Natural Terrarium. The system
®
Monsoon
®
Publicité
