Publicité
Les langues disponibles
Les langues disponibles
F
14. Make sure that the filter is properly connected to the spigot on the
underside of the control unit and placed inside the reservoir.
15. Ensure that the top of the Monsoon MULTI unit fits tightly on top
of the reservoir.
16. Open the small lid on top of the unit, and fill the reservoir with
de-mineralized/distilled water up to a maximum of 2,5 cm (1") from
G
the top rim of the transparent reservoir. (Using regular tap water
will cause clogging of the nozzles by mineral deposits!) (fig. G)
17. Close the lid and connect the power supply jack to the back of
the unit.
18. Make sure the unit is in its final operating location, on a solid,
level surface.
19. Plug the power adaptor into the wall socket, your Exo Terra
Monsoon MULTI High-pressure Misting system is now ready to use.
In order to remove the tubing from either the Y-connector or the
unit, press and hold the blue ring down, while pulling out the tubing.
Please note that nozzles can be mounted in multiple terrariums.
INSTALLATION – OTHER TERRARIUM MODELS
Refer to your terrarium's instruction manual for instructions on how to install
equipment, wiring and tubing inside the terrarium.
1. Mount the nozzles in position on the glass portion of the terrarium's
side panels with the suction cups. Make sure that the glass area is
clean and free of any dirt or deposits before mounting the nozzles.
For the best results, mount the nozzles as close as possible to the
front opening windows and the top screen.
2. Direct the nozzle positions inside the terrarium so that the spray
stream will avoid spraying on the terrarium's front and side panels
when in operation.
®
Publicité
