Honda GP160 Manuel De L'utilisateur page 7

Masquer les pouces Voir aussi pour GP160:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 17
REFUELING
Recommended Fuel
Unleaded gasoline
Research octane rating 91 or higher
Pump octane rating 86 or higher
This engine is certified to operate on unleaded gasoline with a
research octane rating of 91 or higher (a pump octane rating of 86
or higher).
Refuel in a well ventilated area with the engine stopped. If the
engine has been running, allow it to cool first. Never refuel the
engine inside a building where gasoline fumes may reach flames or
sparks.
You may use unleaded gasoline containing no more than 10%
ethanol (E10) or 5% methanol by volume. In addition, methanol
must contain cosolvents and corrosion inhibitors. Use of fuels with
content of ethanol or methanol greater than shown above may
cause starting and/or performance problems. It may also damage
metal, rubber, and plastic parts of the fuel system. Engine damage
or performance problems that result from using a fuel with
percentages of ethanol or methanol greater than shown above are
not covered under the Warranty.
If your equipment will be used on an infrequent or intermittent
basis, please refer to the ''Fuel'' section of the
ENGINE
chapter (see page 11) for additional information regarding
fuel deterioration.
Never use stale or contaminated gasoline or an oil/gasoline mixture.
Avoid getting dirt or water in the fuel tank.
Gasoline is highly flammable and explosive, and you
can be burned or seriously injured when refueling.
• Stop the engine and keep heat, sparks, and flame
away.
• Refuel only outdoors.
• Wipe up spills immediately.
Fuel can damage paint and some types of plastic. Be careful not to
spill fuel when filling your fuel tank. Damage caused by spilled fuel
is not covered under the Warranty.
For refueling, refer to the manufacturer's instructions provided with
the equipment. See the following for a Honda supplied standard
fuel tank refueling instruction.
1. With the engine stopped and on a level surface, remove the fuel
filler cap and check the fuel level. Refill the tank if the fuel level
is low.
2. Add fuel to the maximum fuel level of the fuel tank. Do not fill
the fuel tank completely. Do not overfill. Wipe up spilled fuel
before starting the engine.
3. Refuel carefully to avoid spilling fuel. Fill tank to approximately
25 mm below the top of the fuel tank to allow for fuel
expansion. It may be necessary to lower the fuel level
depending on operating conditions. After refueling, tighten the
fuel filler cap securely.
Keep gasoline away from appliance pilot lights, barbecues, electric
appliances, power tools, etc.
STORING YOUR
Spilled fuel is not only a fire hazard, it causes environmental
damage. Wipe up spills immediately.
ENGINE OIL
Oil is a major factor affecting performance and service life.
Use 4-stroke automotive detergent oil.
Recommended Oil
Use 4-stroke motor oil that meets or exceeds the requirements for
API service category SE or later (or equivalent). Always check the
API service label on the oil container to be sure it includes the
letters SE or later (or equivalent).
SAE 10W-30 is recommended for general use. Other viscosities
shown in the chart may be used when the average temperature in
your area is within the indicated range.
Wash your hands with soap and water after handling used oil.
ENGLISH
FUEL TANK TOP
25 mm
AMBIENT TEMPERATURE
FUEL TANK CAP
MAXIMUM FUEL LEVEL
7

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Gp200

Table des Matières