The "Stay" Command; Eliminating Unwanted Behaviour - Petsafe PDT20-11738 Manuel D'utilisation

The "Stay" Command

1. Put a separate, non-metallic collar on your pet's neck BELOW the Receiver Collar, and attach a
3-metre lead.
2. Put your pet on his bed. Hold your lead in one hand and the Remote Transmitter in the other.
3. Staying within 91 centimetres, walk the perimeter of the bed. Do not say anything to your pet.
4. If your pet tries to leave the bed, press and hold the Lower Button (Spray Correction) and give the
"Stay" command. Continue to hold the button until your pet is back on his bed. If necessary, use the
lead to guide your pet onto his place.
5. Praise your pet when he is back on his bed.
6. Once your pet has settled for a few seconds, release him and play calmly.
7. Repeat steps 1 through 5.
____________________________________________________________________

Eliminating Unwanted Behaviour

Jumping Up
Pets typically jump up to get attention. If you do not want your pet to jump on you, then friends or members
of the family should not encourage this behaviour. That means every time your pet jumps on someone, he
should be reprimanded or redirected to an alternate and acceptable behaviour, for which he can receive
praise.
Note: It is best if your pet first understands the "Sit" command.
1. Choose your pet's Recognition Level.
2. As soon as your pet lifts his paws off the
ground to jump on you, press the Lower
Button (Spray Correction) and give the
command "Sit."
3. Release the Lower Button (Spray Correction)
immediately once your pet is sitting, and
verbally praise him.
4. If your pet ignores the spray correction,
increase the Spray Level by 1.
5. Practice this exercise in several different areas
and use different people for distractions.
14 www.petsafe.net