Cleaning The Cat Door; Replacement Flap Installation Instructions; Terms Of Use And Limitation Of Liability - Petsafe HPA11-10876 Guide D'installation

Cleaning the Cat Door

Your cat door is constructed in the highest quality material with a toughened flap and has been
designed to last for many years. To maintain its appearance, occasional wiping with a damp cloth is
all that is necessary.

Replacement Flap Installation Instructions

1. From the inside of the house, ensure that the 4-Way Lock is in position 4 (Opened).
2. If installed in a door or wall greater than 2 1/4" (57 mm) thick, remove interior frame cover from the
interior frame by unsnapping the snaps, starting with the snaps closest to the top on each side of the door.
If installed in a door or wall less than 2 1/4" (57 mm) thick, remove the two finishing plugs
(half-way down on either side of the exterior frame) and then remove the screws. The cat door will
now come away from the door. The part of the cat door that is on the inside of the house should be
dismantled. To do this remove the screws from the back of the interior frame. Remove interior frame
cover from the interior frame by unsnapping the snaps, starting with the snaps closest to the top on
each side of the door.
3. Remove only the old flap and the flap magnet assembly, leaving the jamb seal magnet and hinge
springs in the frame.
4. Place the new flap into the frame ensuring that the flap seal magnet and jamb seal magnet are
attracting and not repelling. To ensure that this is the case, on the flap, the word "PetSafe
read from left to right.
5. If installed in a door or wall greater than 2 1/4" (57 mm) thick, reattach interior frame cover by
snapping it in place. Insert the bottom hooks of the frame cover first and then rotate it into place.
Reposition the 4-way lock to the desired setting.
If installed in a door or wall less than 2 1/4" (57 mm) thick, reattach interior frame cover by
snapping it in place. Insert the bottom hooks of the frame cover first and then rotate it into place.
When the interior frame and the interior frame cover edges are flush, turn the assembly over and
replace the screws. Replace the cat door into the hole in your door/wall, line up the outside frame
and screw back into place. Re-cover the screw holes with the finishing plugs and finally reposition
the 4-Way Lock to the desired setting.
Replacement flaps are available online at www.petsafe.net or by contacting the Customer Care Center.

Terms of Use and Limitation of Liability

1. Terms of Use
This Product is offered to you conditioned upon your acceptance without modification of the terms, conditions and
notices contained herein. Usage of this Product implies acceptance of all such terms, conditions, and notices.
2. Proper Use
This Product is designed for use with pets where training is desired. The specific temperament of your pet may not
work with this Product. If you are unsure whether this is appropriate for your pet, please consult your veterinarian
or certified trainer. Proper use includes reviewing the entire Operating Guide provided with your Product and any
specific Caution statements.
3. No Unlawful or Prohibited Use
This Product is designed for use with pets only. This pet training device is not intended to harm, injure, or
provoke. Using this Product in a way that is not intended could result in violation of Federal, State or local laws.
4. Limitation of Liability
In no event shall Radio Systems Corporation be liable for any direct, indirect, punitive, incidental, special or
consequential damages, or any damages whatsoever arising out of or connected with the use or misuse of this
Product. Buyer assumes all risks and liability from the use of this Product.
5. Modification of Terms and Conditions
Radio Systems Corporation reserves the right to change the terms, conditions and notices under which this
Product is offered.
10 Customer Care Center 1-800-732-2677
" should
®