Pairing With A Device That Has An Nfc Function - Sony CMT-SBT20 Mode D'emploi

Note
• If playback does not start after pressing  
in step 4 of "Pairing with a device that does not
have an NFC function" (page 20), press  
again or start the playback on the BLUETOOTH
device.
• Operations may vary depending on your
BLUETOOTH device.
• This system can be paired with up to 8
BLUETOOTH devices. If a new device is paired
after 8 devices have been paired, pairing
information of the device that was connected
with the system first is overwritten with that of
the new device.
• Once a pairing operation is performed, it does
not have to be performed again. In the following
cases, however, a pairing operation must be
performed again:
– Pairing information was deleted due to repair,
etc.
– Pairing registration information of this system
is deleted on the BLUETOOTH device.
– If you reset the system to factory settings
(page 31), all the pairing information will be
deleted.
• The sound of this system cannot be sent to a
BLUETOOTH speaker.
• "Passkey" may be called "Passcode," "PIN code,"
"PIN number" or "Password," etc.
• You cannot make a BLUETOOTH connection
with another BLUETOOTH device while the
BLUETOOTH connection is established with one
BLUETOOTH device. Terminate the connection
first, and then connect with a new device.
• Sub Band Codec (SBC) is the only supported
codec.
Pairing with a device that
has an NFC function
Compatible smartphones are those
equipped with the NFC function (compatible
operating system: Android™ version 2.3.3 or
later with the exception of Android 3.x).
For details, see "Websites for compatible
devices" (page 34).
What is "NFC"?
NFC (Near Field Communication) is a technology
enabling short-range wireless communication
between various devices, such as mobile phones
and IC tags. Thanks to the NFC function, data
communication can be achieved easily just by
touching the relevant symbol or designated
location on NFC compatible devices.
1
Turn on the NFC function of the
smartphone/tablet.
For details, refer to the operating
instructions supplied with the
smartphone/tablet.
2
Touch the smartphone/tablet on
the N-mark  on the unit.
Follow the on-screen instructions to
establish the connection. When the
BLUETOOTH connection is established,
"BT AUDIO" appears on the display  .
Smartphone/
tablet responds
once system is
recognized
21
GB