Operation; Applications; Installing/Removing Battery Pack - Ryobi P2903 Manuel D'utilisation

WARNING:
Contact your local utility for underground service marking
before using this product to avoid contact with under-
ground utilities.
WARNING:
To reduce the risk of electrocution, never use the auger
near any buried electrical power cables. Contact with or
use near buried electrical power cables may cause seri-
ous injury or electric shock resulting in death.
WARNING:
To reduce the risk of explosion, never use the auger near
any buried gas lines, including water lines and pipes.
Contact with or use near buried water or gas lines may
result in bursting of water lines and explosion from gas
lines which may cause serious injury or death.
WARNING:
Do not allow familiarity with this product to make you
careless. Remember that a careless fraction of a second is
sufficient to inflict serious injury.
WARNING:
Always wear eye protection with side shields marked to
comply with ANSI Z87.1. Failure to do so could result in
objects being thrown into your eyes resulting in possible
serious injury.
WARNING:
Do not use any attachments or accessories not recom-
mended by the manufacturer of this product. The use of
attachments or accessories not recommended can result
in serious personal injury.
NOTICE:
Before each use, inspect the entire product for damaged,
missing, or loose parts such as screws, nuts, bolts, caps,
etc. Tighten securely all fasteners and caps and do not
operate this product until all missing or damaged parts
are replaced. Please contact customer service or an
authorized service center for assistance.

OPERATION

APPLICATIONS

You may use this product for the purpose listed below:
 Planting trees, shrubs and flowers
 Cultivating and preparing soil
 Digging of light duty fencing and posts
The cordless hole auger is only intended for use outdoors.
For safety reasons, the tool must be adequately controlled
by a two-handed operation.
The hole auger is designed to make the task of digging holes
much easier for the operator. The recommended maximum
depth of hole for the product is 600 mm.
Do not use the tool for any other purpose.

INSTALLING/REMOVING BATTERY PACK

See Figures 4.
WARNING:
Always remove battery pack from your tool when you are
assembling parts, making adjustments, cleaning, or when
not in use. Removing battery pack will prevent accidental
starting that could cause serious personal injury.
To install:
 Insert the battery pack into the product as shown.
WARNING:
Make sure the latches on the bottom of the battery
pack snap in place and the battery pack is fully seated
and secure in the tool's battery port before beginning
operation. Failure to securely seat the battery pack could
cause the battery pack to fall out, resulting in serious
personal injury.
To remove:
 Depress the latches on the battery pack and remove from
the hole auger.
WARNING:
Battery tools are always in operating condition. Remove
battery pack when transporting or carrying to avoid ac-
cidental starting, which may result in serious injury.
For complete charging instructions, see the operator's manu-
als for your battery pack and charger.
8 — English