Configuring Battery Settings; Communication - Green Cell 1KVAS-EBP Mode D'emploi

CONFIGURING BATTERY SETTINGS

Set the UPS for the number of EBPs installed.
To ensure maximum battery runtime, confi gure the UPS for the correct number of EBPs, refer to Table 8 for the
appropriate setting of battery numbers and type. Use the up and down scroll keys to select the number of battery
strings according to your UPS confi guration:
All UPS and EBP Cabinets
UPS only (internal batteries)
UPS+1EBP
UPS+2EBP
UPS+3EBP
UPS+4EBP
NOTE: The UPS contains one battery string; each EBP contains two battery strings.
CAUTION
• The following process must be performed if the UPS is connected with generator.
• First, turn on the generator, after it runs stably connect output power of the generator to UPS input
terminal, then turn on the UPS. After the UPS is turned on, please connect load one by one.
• It is recommended that the generator capacity is as twice as the UPS rated capacity.
• You had better not use the ECO mode when the quality of the input AC mains is not good.

5 Communication

This section describes the:
• Communication ports (RS-232 and USB)
• Connectivity cards
• Emergency Power-off (EPO)
• Load Segments
• UPSilon2000 Power Management Software
22 / EN
Table 8: Battery number Confi guration
Number of Battery Strings
1 (default)
3
5
7
9
FIG 20
1. Output Socket
2. Battery Socket
3. Internal SNMP Slot
4. Net Surge Protect
(optional)
5. Fan
6. RS232, USB
7. AC Input
8. Input Breaker
9. EPO