Installation - Green Cell 1KVAS-EBP Mode D'emploi

FIG 7: Extract UPS front cover
1. Battery
2. Black wire
3. Red wire
FIG 9: Long backup external battery connection
2. Connect the internal battery connector (see FIG. 8)
Connect red to red, Press the connector tightly together to ensure a proper connection.
Remarks: Please note above step 1 & 2 only for replacing batteries or adding the internal batteries. The
plug will be connected properly if the UPS is with batteries installed.
CAUTION: A small amount of arcing may occur when connecting the internal batteries. This is normal and
will not harm personnel. Connect the cables quickly and fi rmly.
3. If you are installing EBPS, see the following section, "Connecting the EBP (s)," before continuing with the UPS

installation.

4. Replace the UPS front cover.
To replace the cover, verify the EBP cable is routed through the knockout on the bottom of the cover if EBPS are
installed.
Put the front cover hooks of side with display to the cover port, put another side to the other two ports, then press it
until the cover and the chassis are combined tightly.
5. If you are installing power management software, connect your computer to one of the communication ports or
optional connectivity card. For the communication ports, use an appropriate cable.
6. If your rack has conductors for grounding or bonding of ungrounded metal parts, connect the ground cable (not
supplied) to the ground bonding screw. See "Rear Covers" for the location of the ground bonding screw for each
model.
10 / EN
FIG 8: Connecting the UPS Internal Batteries
1. Top EBP Cable Knockout
2. EBP Cover Hooks (2places)
3. Insert the two thin-wall into the slot
FIG 10