Display Functions - Green Cell 1KVAS-EBP Mode D'emploi

DISPLAY FUNCTIONS

As the default or after 5 minutes of inactivity, the LCD displays the output parameters.
The backlit LCD automatically dims after 5 minutes of inactivity. Press any button to restore the screen.
LCD display comprises numerical value section, capacity graphics section, fan-status graphics section and charger-
-status graphics section , refer to Table 4 for detail.
Section
Numerical value section
Capacity graphics section
Fan-status graphics section
Charger-status graphics section
16 / EN
Table 4: LCD display section
Description
Display the corresponding numeri-
cal value of inquiring items (output,
load, temperature, input, battery),
for example, as the graphics shows
above, the output voltage is 230v,
the output frequency is 50Hz.
Display the capacity of the battery
and load. Every pane represents
20%capacity. As graphics shown
above, the load reaches 80%-100%
(5 panes), the capacity of the batte-
ry is 40%-60% (3 panes). When UPS
is overloaded, the icon will fl ash,
when battery is weak or disconnec-
ted, the icon will also fl ash.
Display if the fan works normally.
When the fan works normally, it
will show the dynamic fan blades
rotating; when the fan works ab-
normally, the icon will keep on
fl ashing with the WARNING.
Display the status of the charger.
When charger works normally,
the corresponding icon will vary
dynamically and orderly.
when charger works abnormally,
the icon will keep fl ashing
When UPS is in battery mode, the
number of the icons of the charger-
-state section will vary according
to the changeable capacity of the
battery (pane).
Graphic